A LITTLE YARN. A LITTLE PATIENCE. SOMETHING LOVELY.
cozy pattern laneCROCHET · QUILTING · SLOW MAKING
Christmas · Complete free written pattern

Wrapped in Joy Table Runner

🖨️ Prefer to sew from paper? Printable PDF patterns are in our Etsy shop ↗

Make three ribbon-wrapped presents with pieced bows, pale ribbons, a cranberry frame and a green bound edge. This complete recipe covers every cut and assembly stage.

Raw pieced top
42½ × 16½ in
Skill / units
Confident beginner · inches
Piecing seam
¼ inch, included in cut sizes
Jump to the cutting list ↓

Read everything here without registering. Checkboxes keep progress only while this page remains open.

Design visualization for Wrapped in Joy Table Runner
Design visualization, not a photograph of a physically tested sample.

Complete written pattern · counts checked on paper. Adapted from our existing illustrated project edition and checked for written counts and assembly consistency. Fabric use, finished fit and behavior still need a physical sample. Raw-top measurements are not promises of the bound or washed size.

Fabric and tools

Amounts are planning allowances, not measured consumption from a sewn sample. Check usable fabric dimensions after preparation. For a quilting service or frame that needs more backing margin, increase the backing and batting before cutting.

Fabric / purposePlanning allowance
Red cotton¾ yd
Green cotton, including binding¾ yd
Cream cotton1 yd
Backing1½ yd; cut 22 × 48 in
Batting22 × 48 in
  • Sewing machine, coordinating thread and a ¼-inch foot or seam guide
  • Rotary cutter, cutting mat, inch-marked quilting ruler and fabric marker
  • Iron, pins or clips, basting supplies, quilting foot if available and a hand-sewing needle

Complete cutting list

All sizes below include seam allowance. Dimensions are width × height unless a specific step identifies fabric length or width of fabric (WOF). Do not add a second allowance. Mark each pile before sewing.

Piece / fabricQuantityCut size
A upper panels · red / green4 red + 2 green5 × 2½ in
B lower panels · red / green4 red + 2 green5 × 5½ in
C bow starters · red / green4 red + 2 green3 × 3 in
D cream bow starters63 × 3 in
E cream bow sides64½ × 4½ in
F upper vertical ribbon3 cream1½ × 2½ in
G lower vertical ribbon3 cream1½ × 5½ in
H horizontal ribbon3 cream10½ × 1½ in
I gift side strips6 cream1½ × 8½ in
J block gaps2 cream1½ × 12½ in
K inner long borders2 cream38½ × 1½ in
L inner end borders2 cream1½ × 14½ in
M outer long borders2 red40½ × 1½ in
N outer end borders2 red1½ × 16½ in
P binding4 green strips2½ × 42 in

01 Read the construction and prepare fabric

The nominal visible design is 42 × 16 inches. Its raw top is 42½ × 16½ inches. All cuts include ¼-inch allowances and assume 42 usable inches across the fabric. Work with non-directional prints or solids and label pieces A–P before sewing.

Make one complete block before repeating the other two. Use a seam test with two spare 1½-inch-wide strips: after a ¼-inch long-edge join and pressing, they should measure 2½ inches across. This is decorative table linen, not a heat-rated trivet.

02 Make twelve half-square-triangle bow units

Pair each colored C square with one cream D square, right sides together. There are six pairs: four red/cream and two green/cream. Draw one diagonal on the cream wrong side.

03 Arrange each bow precisely

Use four matching-color HST units per bow. Colored triangle placement, viewed from the front, is: upper-left unit = lower-left colored half; upper-right = lower-right colored half; lower-left = upper-left colored half; lower-right = upper-right colored half. Together these form two wings meeting in the middle.

Join the top two units and then the lower two. Each row is 4½ × 2½ inches. Press the upper row’s center seam left and the lower row’s right. Nest the rows, join and press the joining seam open. Each bow is 4½ inches square. Make two red bows and one green bow.

Colored wings meet in the middleFour 2½-in units → one 4½-in unfinished bow
Front-view bow orientation. The dashed cross separates the four HST units. In order upper-left, upper-right, lower-left, lower-right, colored halves are bottom-left, bottom-right, top-left and top-right.

04 Make bow rows and the ribbon-wrapped bodies

Add one cream E square to each side of each bow. Press toward cream; each bow row is 12½ × 4½ inches. Keep the bow color matched to its gift body.

05 Finish the gifts, then join the center

Join each matching bow row to the top of its gift body, right sides together. Match ends and centers. Press toward the bow row. The block is 12½ inches square: 4½ + 8½ − ½ = 12½. Make two red blocks and one green.

Arrange red gift – J spacer – green gift – J spacer – red gift. Every bow stays at the top. Join with ¼-inch seams and press toward the cream spacers. The center should be 38½ × 12½ inches.

Red gift · cream gap · green gift · cream gap · red giftBow row above body; vertical ribbons stay aligned
Front-view gift placement with cream and red frames. The green edge is added as binding after quilting and is not another border. Diagram omits raw seam allowances.

06 Frame the gifts

Add the strips below in this order, matching ends and centers and pressing toward each new frame. These are square-ended frame joins; the green outside edge in the visualization is binding added later.

Pieces and placementUnfinished result
K: 38½ × 1½ in cream, top/bottom38½ × 14½ in
L: 1½ × 14½ in cream, ends40½ × 14½ in
M: 40½ × 1½ in red, top/bottom40½ × 16½ in
N: 1½ × 16½ in red, ends42½ × 16½ in

07 Layer, baste and quilt

Prepare backing and batting at least 22 × 48 inches, or larger if your quilting setup requires it. Keep both oversized until quilting is complete. The planned raw top is 42½ × 16½ inches.

TOP · right side upMIDDLE · battingBOTTOM · backing, wrong side up
Exploded layer diagram. In the actual sandwich, the three layers lie flat together. Backing right side faces the table; the pieced top faces you. Keep backing and batting oversized for quilting.

08 Attach the binding and finish the back

Use 4 strips cut 2½ × 42 inches. This project joins the strips with diagonal seams and closes the final attachment with a tucked overlap. The estimated continuous strip length before end cleanup is 160.5 inches. Measure the actual prepared length before attaching it.

09 Resolve bow and ribbon problems before quilting

For an incorrect bow silhouette, compare all four colored triangle halves with the orientation instructions and diagram. Putting the same orientation into every HST position will not create matching wings.

If a vertical ribbon shifts, examine the A/F/A and B/G/B seams before pulling the rows toward each other. If a long border waves, measure the center and strip lengths. The raw perimeter is 118 inches; four diagonal-joined binding strips yield about 160½ inches before cleanup.

Keep these measurement checks beside you

StageRaw / unfinished measurement
Bow4½ × 4½ in
Bow row12½ × 4½ in
Gift body with sides12½ × 8½ in
Complete gift12½ × 12½ in
Center38½ × 12½ in
Raw top42½ × 16½ in

Check after pressing and cooling, without stretching. If an earlier unit is incorrect, correct it there before adding the next component.

Your project record

  • Chosen fabrics, preparation method and usable widths.
  • Quarter-inch seam test and first unit measurements.
  • Actual backing allowance and batting quilting requirements.
  • Quilting method, finished measurements and changes for a future version.

Written review: November 5, 2026. Images illustrate the design; diagrams explain placement. No physical test result is claimed.

← All free quilting patterns